[phenixbb] AutoBuild after resolve

Thomas C. Terwilliger terwilliger at lanl.gov
Fri Feb 27 16:49:06 PST 2009

Hi Mo,

There isn't any place in the AutoBuild GUI specifically for
"phases_from_resolve".  If you really want to set this parameter you can
go to the "uncommon inputs" window and set "resolve_command" to

I think that you don't want to do this, however.  I am assuming that this
means that you are using a density-modified map as input to AutoBuild with

What you want to do instead is say (or set in the GUI):

data=my_experimental_fobs_and_phases.mtz \

and then AutoBuild will start from your density modified map, but it will
use experimental phase information as the prior phase information. It will
also automatically set the parameter "phases_from_resolve" so that that
you do not have to.

I hope that helps!
-Tom T

Hi all,

Can someone tell me where in the AutoBuild GUI I can set
"phases_from_resolve"? I've looked for it in the "set variable" section,
it's not listed.

phenixbb mailing list
phenixbb at phenix-online.org

More information about the phenixbb mailing list